Standard Model 2922-287300 (aluminum – white) Bradex® Bradex® Product Materials 2922-2873 COVER: die-cast aluminum finished with white epoxy paint with Steritouch® 2922-2874 COVER: one-piece stainless steel; satin finish Cover fixed to the base plate with tamper proof screws. ADJUSTABLE MOTOR: motor is a thermally-protected universal type operating at 23,400 RPM. Adjustable motor control switch has three settings; HI, MED and LOW. HEATING ELEMENT: 400 watt heating element constructed of nichrome wire and protected by an automatic resetting thermal cutoff. Heater can be turned ON or OFF via internal switch. SENSOR OPERATION: Automatic infrared sensor with a 3 second run-on time and a 30 second vandal shut-off. BASE PLATE: Aluminum with four mounting holes and a .88″ knockout. Installation Verify all rough-in dimensions prior to installation. Hand dryers require a dedicated 15 amp circuit and must be properly grounded. GFI Circuit protection is recommended. One side of dryer should be mounted to a stud. For proper mounting heights, see installation manual. Operation Place hands 3″–6″ below nozzle to activate air flow. Dryer will stop after hands are removed from air flow.
Guide Specification Surface-mounted hand dryer shall have a white cast aluminum cover with epoxy paint (2922-2873) or stainless steel cover with satin finish (2922-2874). All internal air flow paths shall incorporate SteriTouch antimicrobial technology. Hand dryer shall include aluminum base plate, adjustable universal type motor and infrared sensor. Dryer shall operate at 73 – 85 dB while delivering 78-100 CFM air at a velocity of 250 – 265 MPH or 22,000 – 23,320 LFM. Dryer shall produce air at 110 – 140°F. Dryer shall have total power of 400 – 1200 watts with a consumption of 3.3 – 10.0 A. Overall dimensions: 12.5″H x 9.3″W x 7.6″D (319mm x 236mm x 192mm). Weight: Aluminum – 11.6 lb (5.2 kg) Stainless Steel – 14.2 lb (6.4 kg) Product Specifications Voltage: 100–120 V Consumption: 3.3–10.0 A Nominal power: 400–1200 W RPM: 23,400 Airflow: 78–100 CFM Heating element: 400 W Noise level: 73–85 dB Airspeed: 250–265 MPH Frequency: 60 Hz Insulation: Grounding required Temperature: 110ºF–140ºF (43ºC–60ºC) Certificates: UL 499 / CSA C22.2 (No. 36-08) Drying time: 10–12 seconds Mounting: Surface; not ADA compliant With recess kit*; ADA compliant Protection level: IP24